ASI-Netzwerkadapter (DS3 E3)

1 safety instruction
1.1 Before starting using this unit, please be sure to refer to this manual.
1.2 Do not to open the cabinet, otherwise the guarantee to repair are not available. Meanwhile touching the inside makes you in great danger of electric shock.
1.3 Please make sure to cut off the power supply if you will not use this unit in long term, and do not use any broken jack, which could result in fire or electric shock.
1.4 Wet hands are forbidden to touch the power jack, to avoid risk of electric shock.
1.5 Please pull the plug itself instead of the wire when you pull out power plug, .
1.6 Any thing flammable and metal or liquid, which will destroy the decoder, must be kept out the box.
1.7 Do not place this unit in a location near a heat source such as radiator or air ducts, or in a place exposed to direct sunlight, excessive dust, moisture, rain, mechanical vibration.
1.8 Keep the device working in a good ventilative environment, if not the destruction will occur.
1.9 Please keep the packaging for the safety of transit.
2 system introduction and operating principle
Tc-4100converts signals between DVB interface and e3/ds3 interface for connecting sdh/ATM and hfc or mmds networks. Therefore tc-4100is widely used in sdh/ATM, pdh, hfc, digital mmds, 8GHz system, etc.
Tc-4100 SA converts DVB spi input to DVB asi output
Tc-4100 aed converts DVB asi input to e3 or ds3 output
Tc-4100 eda converts e3 or ds3 input to DVB asi output
Asi/spi
E3/ ds3
Signal output
Tc-4100consists of three modules as follows:
Input interfaces
Receiving DVB asi, sdh e3, ds3, completeing the signal input processing.
Data processing
The unit processes data and carries out protocol conversion.
Output interface
Outputs required signals.
3. Main features
Asi input data channel support 216mpbs (max)
PCR correction
8 pid filter
Empty packet filter automatically
Empty packet automatic filling and output bit rate invariablenes
188 and 204 packet automatic identification
E3/ds3 input or output could be setted agilely
Failure alarming
LCD display to carry out system status supervision and system parameters setup
Power off memory
4. Technical specifications:
4.1 input interface characteristics
Ds3/e3 (g. 703 standard)
Connector: BNC
Impedance: 75ω
Ts packet format: 188/204 bytes
Input bit rate: 44.736mbps(ds3)
34.368mbps(e3)
Encode: B3zs(ds3)
Hdb3(e3)
Asi ( DVB standard. }
Connector: BNC
Uniestar